fine art

home & garden


work in progress


3-d printer
ahp tools
engineering kinetic sculpture
everlast tools
finish work & patinas
focus on art
how to create a sculpture
longevity tools
milling machine & metal lathe
public art
shop math: measuring & leveling
studio tour
tools for the studio
transporting & installing videos
arc welding
bending & shaping
cutting & grinding
general welding
health & safety
mig welding
other techniques
specific projects
tig welding
tool how-to's

  * Why You Should Read the @#$% Manual
  * How to Stick Weld 1/4" Steel Plate Using the Everlast Power i-MIG 253DPi
  * The Story Behind ... My Gordian Accordian Sculpture Series
  * Should You Use a Lap Joint or a Butt Joint When Welding?
  * Can You Cut Rusty Metal And Paint With A Plasma Cutter?

more ...

"[Flow] is so beautiful. It is amazing to have a real piece of rock instead of that ugly 'fake' rock that fountains are built out of these days. I am so glad I discovered Kevin's work online."
--Anita Rockett, Rockett Advertising executive, El Paso, Texas

Bookmark and Share

< Back
Next >

Why You Need to Clean Metal Before Welding

Kevin is asked to prove that it matters if the metal you are welding is clean. What happens if you don't clean the metal at all? He asks, "Why do you have to take the metal until its bright and shiny before welding? Why do you get rid of the rust?"

You clean the metal because the rust, and any imperfections such grease, millscale, paint, whatever, because otherwise, when you start welding, the contaminants burn, bubble, outgas and do all kinds of crazy things because you have all these foreign bodies mixed into the molten puddle.

The worst thing it does is weaken the weld. Any stress, flex or pull could cause the weld to fail and pop apart. If your welds have to be certified, such as in the food or nuclear industries where they check the welds with X-ray machines, they'll probably find a pocket in the weld. Then you have to grind it out and start from the beginning.

Kevin grabs two rusty railroad spikes. He has his vise clamped to the table and his ground attached to the table. He puts one spike in the vise, wiggling it around a little to get an electrical contact. He's set his Everlast PowerMTS 251Si on 170 amps and is using a freshly ground, 1/8" tungsten.

He lowers his welding helmet and TIG welds the railroad spikes together. Sparks are flying.

How many other things went wrong? The end of the tungsten melted from all of the contaminants bubbling up. The weld itself started OK, but then you see porosity, and the weld ended with a crater. "Pretty darn ugly looking," admits Kevin. He suspects that, if he cut the weld open and etched it, you wouldn't find much penetration.

Just to show you the difference, Kevin takes two spikes with shiny spots that he has cleaned up on the grinder, removing enough surface to get rid of rust and any other contamination. He cleaned up the sides of one spike, too, so he could get a good electrical contact. He sets up the clean spikes just like the earlier, dirty spikes and TIG welds them together.

This second weld is much quieter and cleaner, without the sparks. Then he shows the two welds, which are obviously different. Kevin hopes this answers your questions about whether you need to clean metal before welding, and SOMEONE owes him a six pack!

Don't miss Kevin being, well, kinda disrespectful (OK, REALLY disrespectful!) ....

Watch more videos now