fine art

home & garden

jewelry

work in progress

videos

3-d printer
ahp tools
engineering kinetic sculpture
everlast tools
finish work & patinas
focus on art
how to create a sculpture
longevity tools
milling machine & metal lathe
public art
shop math: measuring & leveling
studio tour
tools for the studio
transporting & installing
weld.com videos
arc welding
bending & shaping
cutting & grinding
general welding
health & safety
mig welding
other techniques
oxygen-acetylene
specific projects
tig welding
tool how-to's

RECENT VIDEOS
  * How to Have a Pocketful of Tools - Using a Level
  * How to Start & Run a Successful Art Career
  * What's Wrong With My TIG Tungsten?
  * How to Shape Metal With Hand & Power Tools
  * How to Bend Square Tubing So It Doesn't Kink


more ...



"I love my Shitake Agave! On my first daylight look, a bright red cardinal flew right over and perched on it! Thank you, thank you! ... I couldn't bear to put my caterpillar outside - he lives on my hearth!"
--Sam Kathryn Campana, Vice President and Executive Director, Audubon Arizona, Phoenix, Arizona



Bookmark and Share



< Back
Next >


How to Angle Your Plasma Cutter for the Best Cut



Kevin got a question the other day: "When you're cutting with a plasma cutter, can you go too fast? How do you judge the correct speed for cutting?"

There are a couple of things you really want to keep in mind when you're using a plasma cutter.

One, of course, is just to make sure you're about an eighth of an inch or so above your metal - that's a good height to start with. Then, as you start moving along and making your cut, watch for sparks coming along the top of the metal. You're also going to try to watch the arc below the metal.

Kevin shows a piece of half inch steel plate. He's going to start on one side of the metal and make a cut across it, going too fast. Watch the arc coming out of the bottom. He cuts the steel, and you can see the arc bend forward, then back.

When you're going too fast like that, you're going to get a really ragged cut. It's just going to look awful.

If you're cutting really, really too fast, sparks will actually come out on the top of the metal, because you're not cutting all the way through the bottom. You're basically just gouging the metal. Kevin turns the plasma cutter back on.

He cuts across the piece of metal again going even faster. This time sparks shoot out across the top of the steel plate. Very, very little of the arc goes down under the metal. As Kevin shows, the cut never even came through the other side.

So Kevin hopes that answers the question.

Before you go, you might want to stick around for a moment to see Kevin struggle to define "bad" ....


Watch more videos now